The Kingclean doctor blade holder
has been designed for cleaning rolls located in the difficult-to-reach
and dirty locations on a paper machine, and where blade changing
is troublesome. Most commonly used in the dryer section, but
can also be applied to application in which roll cleaning
is critical. What sets the Kingclean apart from other blade
holders is its open fingertip design, a unique feature that
eliminates clogging due to paper dust and "stickies."
The holder also allows for easy blade removal even under the
most severe conditions. It is available in Mild Steel and
304/316 Stainless steel.
The design allows for rapid blade
changing. Both front and end-removal blades are easily and
quickly changed by simply pulling the worn blade across the
holder assembly. The pull-through action disturbs particle
build-up in the holder, leaving it clean to accept the new
blade. The holder is profiled to the roll at installation,
eliminating the need for re-profiling or shimming with each
blade change.
The Kingclean blade holder improves
doctoring efficiency by holding the blade firmly against the
roll. Micro-adjusting screws permit a uniform blade fit across
the roll's entire face. These micro-adjusting screws are located
in the holder immediately behind each mounting bolt and allow
for a 5/32 inch adjustment for surface variations. As an adjusting
screw is forced against the doctor back, it pivots the holder
and blade toward the roll.
Breast Roll, Wire Rolls, Felt Rolls, Dryers, Calendar |